Practical guides covering hose selection, connections, inspection and replacement decisions.
Technical Guide Choose by the complete application and the exact product specification. A standard designation is a useful starting point, but it does not establish interchangeability between assemblies.
Read the Guide → Technical Guide Identify the thread and the sealing arrangement together. Diameter, pitch, taper and seat geometry must agree; a fitting that starts to screw in is not proof of a compatible connection.
Read the Guide → Technical Guide Inspect the complete assembly and its route, investigate repeat failures, and set inspection frequency from the equipment instructions and actual duty. Visible damage needs action, not a cosmetic cover-up.
Read the Guide → Technical Guide Select an assembly using its permitted working pressure under the stated conditions. Burst pressure describes destructive-test performance; it is not extra operating capacity available to the machine.
Read the Guide → Technical Guide Plan mining hose purchases around the circuit, operating conditions and complete assembly. Compare standards, compatibility, protection and supplier evidence before agreeing a replacement.
Read the Guide → Technical Guide Permanent crimped or swaged hose ends are not components to recover for a new hose. Purpose-designed reusable fittings and separate adapters require their own manufacturer instructions and condition assessment.
Read the Guide → Technical Guide Start with the inner tube, not the shiny outer braid. Compare three constructions supplied by RHPL and find the right product page for your enquiry.
Read the Guide → Technical Guide Compare one- and two-wire-braid hydraulic hoses using named catalogue values, then check the exact product and complete assembly before ordering.
Read the Guide → Technical Guide Compare spiral hose construction, public catalogue pressures and bend radii, coupling requirements and selection for heavy equipment.
Read the Guide → Technical Guide Compare BSP and NPT thread forms, TPI and gauge-plane diameters, then identify the correct sealing connection.
Read the Guide → Technical Guide Look up JIC dash sizes, tube diameters and UN/UNF threads, then check the 37° sealing seat before ordering.
Read the Guide → Technical Guide Locate the source of hydraulic oil leakage, distinguish connection faults from failed assemblies, and correct the cause before returning equipment to service.
Read the Guide → Technical Guide Compare workshop crimping requirements with buying prepared hose assemblies for mixed fleets and planned shutdowns.
Read the Guide →